Analog only VHF/UHF dual band receiver single channel
The Radio-To-Intercom Bridge receiver is designed to interface to an existing wired Public Address Intercom system and allow PA or intercom announcements using your Analog two-way radio
Switch Input w/ Pre-Recorded Message – Allows Optional NO or NC switch to activate a recorded voice message played solely on single attached LM receiver/speaker.
Provides interconnection to the Public Address amplifier through a high impedance, unbalanced AUX input or a 600Ω balanced MIC input
Signaling Decode: CTCSS, DCS, DTMF, 2-Tone or Selcall
VHF NOAA WX Alert Frequencies
Each model can operate on VHF LMR business band, UHF LMR business band, or VHF MURS 2-way radios, and can work through radio repeaters.
Radio-To-Intercom Bridge receiver connects to your wired PA/Intercom system amplifier. Allows authorized 2-way radios to make PA announcements over the wired speaker system. Dual band RIB receiver is configurable for either VHF, VHF MURS, UHF, GMRS or FRS frequency band.
Provides interconnection to the Public Address amplifier through a high impedance, unbalanced AUX input, or a 600 Ω, balanced MIC input.
Compatible with other brand 2-way radios, using the same technology (Analog) and operating in VHF or UHF frequency band.
Wireless technology provides a cost-effective and flexible way to provide Public Address / Mass Notification coverage across your entire facility or to isolated pinpoint locations.
